BTW. I tried to copy your settings from your EEPROM into my EEPROM backup, but it still did not cause any problems
I'm running the Soft Reset version at the moment.
But I never had any problems in any version
BTW. I tried to copy your settings from your EEPROM into my EEPROM backup, but it still did not cause any problems
in the soft reset version I observe this:VK3KYY wrote: ↑Wed Feb 17, 2021 9:01 amBTW. I tried to copy your settings from your EEPROM into my EEPROM backup, but it still did not cause any problemsOK2HAD wrote: ↑Wed Feb 17, 2021 8:50 amdownloadingVK3KYY wrote: ↑Wed Feb 17, 2021 8:44 am
Thanks.
I made another test version
Soft Reset of C6000.
Can you try this ?
https://github.com/rogerclarkmelbourne/ ... _C6000.zip
I'm running the Soft Reset version at the moment.
But I never had any problems in any version
Testet Both same or similar problems that before...now testing Soft resetVK3KYY wrote: ↑Wed Feb 17, 2021 7:54 amProbably blocked as spam
I now put it on github
https://github.com/rogerclarkmelbourne/ ... _music.zip
If it doesnt work
Try
https://github.com/rogerclarkmelbourne/ ... e_init.zip
And level 1, 2 and 3
Tell me which levels it works.
Hi, I'm testing this version tomorrow. Now our night starts hereVK3KYY wrote: ↑Wed Feb 17, 2021 8:14 pmOK
In the Soft Reset version, I forgot to resend the custom calibration data for the individual radio to the C6000
So I made a new version
https://github.com/rogerclarkmelbourne/ ... ibrate.zip
However, I don't think this will fix the problem.
Please can both of you make a video showing your exact setup, and TG etc, because at the moment I don't understand if this is some problem with your individual radio hardware, or whether its a problem caused by individual setup.
Although the version from 16th does not have this bug, it consumes 20% more current from the battery when in Level 4, and probably 10% more in level 3, 5% more in level 2 and 2% more in level 1.
So for level 1, this is not so important, but for the other levels, I need to release a version which saves up to 20% more current on Level 4
Thanks for your videos
Installed this version now, thanks Roger.VK3KYY wrote: ↑Thu Feb 18, 2021 6:02 amThanks for your videos
I think the problem may be the audio connection from the CPU to the DMR chip.
I have done another version which suspends the audio system in the DMR chip before the DMR chip is put into sleep mode, and then after the DMR chip is woken up, the audio system is reset
https://github.com/rogerclarkmelbourne/ ... et_I2S.zip
Also, because of the bug reported by OK2HAD, I looked at the problem when the beep volume is changed.
I can't find a bug related to the beep volume, but I did find some other bugs, because of a conflict when the radio is receiving a DMR signal and a beep is played a the same time, and during Tx when the timeout beep is played.
I don't think the changes in this version will fix the beep volume problem, but they were bugs, so they needed to be fixed.
Anyway, try this version.
BTW.
Also if there is still no Rx audio when a signal is received, can you try just changing channel.
Can you also disable Voice Prompts before testing, because I need to fix this for most people who do not use Voice Prompts.
Thanks