MD-UV380 stuck on start up
MD-UV380 stuck on start up
Radio had open RTX installed.
Reloaded factory firmware. many different versions with no help
The radio is now stuck on the splash screen.
Software Version210130
CPS software version V00.00
Hardware Version: V03.00
MCU version V018.003
Can someone please please point me to the correct software version.
THX
Reloaded factory firmware. many different versions with no help
The radio is now stuck on the splash screen.
Software Version210130
CPS software version V00.00
Hardware Version: V03.00
MCU version V018.003
Can someone please please point me to the correct software version.
THX
Re: MD-UV380 stuck on start up
Did you restore the original flash memory?
What happens if you load Opengd77 again, does it start then?
What happens if you load Opengd77 again, does it start then?
Re: MD-UV380 stuck on start up
Double post…
Last edited by N1ETT on Fri Jun 09, 2023 8:47 pm, edited 1 time in total.
Re: MD-UV380 stuck on start up
Yes memory flashed with tyt software
opengd77 message during donor software load is “donor firmware version is not correct”
Re: MD-UV380 stuck on start up
Regarding the flash backup , its not the firmware but a config and data area that has different structures regarding of if you use native or opengd77
firmware.
There is a risk that native firmware can't handle the different flash memory structure when you go back to native firmware.
When you go from native to opengd77 you will notice corrupted config data that will be solved after first config load with OpenGD77 CPS.
But native firmware may have other data areas that aren't solved with a normal config write.
Therefore you should backup native flash with OpenGD77 CPS after the initial load with OpenGD77 firmware.
( Extras -> OpenGD77 Support -> Backup Flash )
The donor software for MD-UV380/RT3S is inside this zip file
https://www.passion-radio.com/index.php ... chment=760
and you should point to MD9600-CSV(2571V5)-V26.45.bin extracted from that zip file.
firmware.
There is a risk that native firmware can't handle the different flash memory structure when you go back to native firmware.
When you go from native to opengd77 you will notice corrupted config data that will be solved after first config load with OpenGD77 CPS.
But native firmware may have other data areas that aren't solved with a normal config write.
Therefore you should backup native flash with OpenGD77 CPS after the initial load with OpenGD77 firmware.
( Extras -> OpenGD77 Support -> Backup Flash )
The donor software for MD-UV380/RT3S is inside this zip file
https://www.passion-radio.com/index.php ... chment=760
and you should point to MD9600-CSV(2571V5)-V26.45.bin extracted from that zip file.
Re: MD-UV380 stuck on start up
The same problem is still persisting.
When checking the calibration data using the TYT CPS everything is blank. This may be a part of the problem resulting from incorrect or incomplete TYT firmware
When checking the calibration data using the TYT CPS everything is blank. This may be a part of the problem resulting from incorrect or incomplete TYT firmware