I have found the fix for this. Change the TX Delay in the pi-star settings from 100 to 0 for the modem.
Stable release (2022 02 28)
Re: Stable release (2022 02 28)
Re: Stable release (2022 02 28)
The stable version of CPS tool is downloaded from there
Re: Stable release (2022 02 28)
Re: Stable release (2022 02 28)
Thank you very much
Re: Stable release (2022 02 28)
Personally, in ''Modem'', I configured my ''TXDelay'' at 50 (originally at 100) since it is thus compatible with all of my radios. The ''DMRDelay'' is at 0 and has not been modified.
For the rest, you have to do a calibration procedure.
Re: Stable release (2022 02 28)
any reason for choosing 50 over 0? i haven't had any problems with the 0 setting yet. Is there anything you run into by setting it less than 50?ve2ugo wrote: ↑Fri Sep 30, 2022 3:36 pmPersonally, in ''Modem'', I configured my ''TXDelay'' at 50 (originally at 100) since it is thus compatible with all of my radios. The ''DMRDelay'' is at 0 and has not been modified.
For the rest, you have to do a calibration procedure.
Re: Stable release (2022 02 28)
I had some problems at 10 so I didn't go all the way to 0. But it depends on the type of HotSpot you have.
For example, my config are not the same on a Chinese JumboSpot as with a duplex Lonestar.
In addition, with some radios, such as Anytone, some hotspot must make a particular configuration so that it responds well...
For example, my config are not the same on a Chinese JumboSpot as with a duplex Lonestar.
In addition, with some radios, such as Anytone, some hotspot must make a particular configuration so that it responds well...
Re: Stable release (2022 02 28)
ve2ugo wrote: ↑Tue Oct 04, 2022 8:04 pmI had some problems at 10 so I didn't go all the way to 0. But it depends on the type of HotSpot you have.
For example, my config are not the same on a Chinese JumboSpot as with a duplex Lonestar.
In addition, with some radios, such as Anytone, some hotspot must make a particular configuration so that it responds well...
Re: Stable release (2022 02 28)
Congratulations on the great teamwork!
Re: Stable release (2022 02 28)
Hello
Link to CPS folder does not work. Must I have that CPS or is it possible to load open firmware with original CPS?
73 Gunnar SA5GNO
Link to CPS folder does not work. Must I have that CPS or is it possible to load open firmware with original CPS?
73 Gunnar SA5GNO