Public Beta (2021 11 14)
Public Beta (2021 11 14)
Some small bug fixes to the previous beta's
https://www.opengd77.com/downloads/PublicBeta_20211114/
Only the firmware file has changed. Not the CPS etc
https://www.opengd77.com/downloads/Publ ... /firmware/
Fixes are only to Suspend mode, where a potential crash bug was fixed by Daniel and also the level of power saving used during suspend is now controlled by the Eco mode setting, in the same way as it currently does while the radio is idle when turned on.
Its possible that the reboot problems are nothing to do with the power saving functionality, becuase there were also bugs in the DMR ID look-up system in some previous versions.
Also some DMR ID data downloads have been seen to contain DMR ID's outside the range of numbers that will fit into the 3 bytes that DMR uses for its IDs. So Daniel put fixes into the CPS to check for invalid ID numbers and exclude them from the data that is uploaded to the radio
https://www.opengd77.com/downloads/PublicBeta_20211114/
Only the firmware file has changed. Not the CPS etc
https://www.opengd77.com/downloads/Publ ... /firmware/
Fixes are only to Suspend mode, where a potential crash bug was fixed by Daniel and also the level of power saving used during suspend is now controlled by the Eco mode setting, in the same way as it currently does while the radio is idle when turned on.
Its possible that the reboot problems are nothing to do with the power saving functionality, becuase there were also bugs in the DMR ID look-up system in some previous versions.
Also some DMR ID data downloads have been seen to contain DMR ID's outside the range of numbers that will fit into the 3 bytes that DMR uses for its IDs. So Daniel put fixes into the CPS to check for invalid ID numbers and exclude them from the data that is uploaded to the radio
Re: Public Beta (2021 11 14)
Good Morning Roger,
Now I have installed the version of today November 14th and I have re-downloaded the id-dmr with the cps OpenGD77CPSInstaller_E2021.11.02.01.exe (operation that I had already done days ago with the same version of cps, before reporting the reboots).
I try the radio starting from echo level 5, if it were to restart I try with other echo levels.
bye, iu4leg
Now I have installed the version of today November 14th and I have re-downloaded the id-dmr with the cps OpenGD77CPSInstaller_E2021.11.02.01.exe (operation that I had already done days ago with the same version of cps, before reporting the reboots).
I try the radio starting from echo level 5, if it were to restart I try with other echo levels.
bye, iu4leg
Re: Public Beta (2021 11 14)
everything works fine for now ... thanks
Sal
Sal
Re: Public Beta (2021 11 14)
ThanksIU4LEG wrote: ↑Sun Nov 14, 2021 8:08 amGood Morning Roger,
Now I have installed the version of today November 14th and I have re-downloaded the id-dmr with the cps OpenGD77CPSInstaller_E2021.11.02.01.exe (operation that I had already done days ago with the same version of cps, before reporting the reboots).
I try the radio starting from echo level 5, if it were to restart I try with other echo levels.
bye, iu4leg
Eco 5 is the most likely to cause the reboot, if the problem is being caused by the power saving. However, I now doubt whether this is the root cause of the problem
Re: Public Beta (2021 11 14)
the radio has been in test for a few hours with echo mode 5, so far it has never restarted yet. I continue the test.
VK3KYY wrote: ↑Sun Nov 14, 2021 9:35 amThanksIU4LEG wrote: ↑Sun Nov 14, 2021 8:08 amGood Morning Roger,
Now I have installed the version of today November 14th and I have re-downloaded the id-dmr with the cps OpenGD77CPSInstaller_E2021.11.02.01.exe (operation that I had already done days ago with the same version of cps, before reporting the reboots).
I try the radio starting from echo level 5, if it were to restart I try with other echo levels.
bye, iu4leg
Eco 5 is the most likely to cause the reboot, if the problem is being caused by the power saving. However, I now doubt whether this is the root cause of the problem
- Fecskebeka
- Posts: 105
- Joined: Thu Jun 03, 2021 7:36 pm
- Location: Hungary
Re: Public Beta (2021 11 14)
But now I've been paying attention to something.
Start-up beep.
And another zone has been loaded.
Unfortunately, a restart has occurred.
I tried to access the radio in DMR mode. Simplex.
I don't think it was in scan mode.
But then I couldn't get her to restart her again.
A little bit different
I notice that the scan mode does not work properly with DMR.
16 DMR channels spun. But it is very difficult to handle the call.
Access is much more stable than previous software.
I watched 30ms, 60ms, 90ms
In addition to 30ms, the analog also works less.
You need to touch to set the noise barrier level. It needs to be lowered significantly.
-----
It was morning
Good morning!
B21201114 went at night for 10 hours already.
Scan mode UHF 16 Analog, 8 DMR channels.
There was no freezing. It still runs nicely. There is rx reception.
There was little in satellite mode in the morning.
Suspend menu: on. I don't know how to see the accidental, faulty reboot. Presumably there was no such mistake.
Have a nice day!
Start-up beep.
And another zone has been loaded.
Unfortunately, a restart has occurred.
I tried to access the radio in DMR mode. Simplex.
I don't think it was in scan mode.
But then I couldn't get her to restart her again.
A little bit different
I notice that the scan mode does not work properly with DMR.
16 DMR channels spun. But it is very difficult to handle the call.
Access is much more stable than previous software.
I watched 30ms, 60ms, 90ms
In addition to 30ms, the analog also works less.
You need to touch to set the noise barrier level. It needs to be lowered significantly.
-----
It was morning
Good morning!
B21201114 went at night for 10 hours already.
Scan mode UHF 16 Analog, 8 DMR channels.
There was no freezing. It still runs nicely. There is rx reception.
There was little in satellite mode in the morning.
Suspend menu: on. I don't know how to see the accidental, faulty reboot. Presumably there was no such mistake.
Have a nice day!
Re: Public Beta (2021 11 14)
Hi VK3KYY, I have translated new language (Macedonian), can you add in next OpenGD77 Firmware ? Many Thanks, Z32IT.