Thinking about a direct zone preset button.
Thinking about a direct zone preset button.
Good morning all,
I was thinking about the following: I switch between zones a lot and now you have to press the blue key + arrow up or down.
Is it possible to sub-program a zone via a preset key (e.g. key 3)? Press a long time and you are taken directly to the desired zone that you have programmed under the key.
I hope that this is possible.
Kind regards,
Bas
I was thinking about the following: I switch between zones a lot and now you have to press the blue key + arrow up or down.
Is it possible to sub-program a zone via a preset key (e.g. key 3)? Press a long time and you are taken directly to the desired zone that you have programmed under the key.
I hope that this is possible.
Kind regards,
Bas
Re: Thinking about a direct zone preset button.
Zones can aleady be assigned to individual QuickKeysShuttrr wrote: ↑Fri Nov 19, 2021 8:24 amGood morning all,
I was thinking about the following: I switch between zones a lot and now you have to press the blue key + arrow up or down.
Is it possible to sub-program a zone via a preset key (e.g. key 3)? Press a long time and you are taken directly to the desired zone that you have programmed under the key.
I hope that this is possible.
Kind regards,
Bas
BTW.
I see you did use your callsign when registering on the site. What is your callsign?
Re: Thinking about a direct zone preset button.
Ok tkx.
QuickKey does not work on my GD77. But Tkx for the awnser.
QuickKey does not work on my GD77. But Tkx for the awnser.
Re: Thinking about a direct zone preset button.
You have to un-assign it first, then assign it. I'm not quite sure why the unassign is required from a factory reset state when none has been assigned before but that's how it works.
https://github.com/LibreDMR/OpenGD77_Us ... #quickkeys
Re: Thinking about a direct zone preset button.
It's because the quick keys are part of the codeplug data.
However, they can't be edited by the CPS because its too complicated to constantly update the CPS to handle every change to menus in the firmware etc
Re: Thinking about a direct zone preset button.
Hi,
It works now. Did reinstall the firmware and now i can confirm the QuickKey's.
Tkx for the help.
Greets Bas
It works now. Did reinstall the firmware and now i can confirm the QuickKey's.
Tkx for the help.
Greets Bas