Have a nice day!
-Can the preferred TX channel for PTT pressure be set in continuous scanning mode?
When there is no signal received. The radio spins, scans.
Do not accidentally shut down.
But in the case of received RX reception, TX can be issued at the stop frequency, and then wait for a while for a possible response at the end of transmission. If there is no response, scanning will continue.
- In Continuous Scanning mode, then after using PTT, at the end of TX can scanning start again automatically?
Similarly, the "Scan On Boot: On" status. When the radio is switched on.
Thanks!
Scanning and PTT
Re: Scanning and PTT
This is a personal customisation.
Recommencing a scan after the PTT has been pressed would not suit many users.
Recommencing a scan after the PTT has been pressed would not suit many users.