DM-1701 - Win11 Driver Error (STM Device in DFU mode)
Posted: Tue Apr 23, 2024 1:30 pm
I just upgraded the CPS to the latest version (portable install & driver installation)
When connecting the DM-1701 (already in Flash-Mode - LED red/green flashing) to my kenwood - USB cabel, I get the warning, that the device was not connected properly. Moreover I get a warning in the Win device-manger - "STM Device in DFU Mode" - but with a waring sign!
Previously my setup (same cable etc) worked flawlessly...
As well as I upgraded my RT3s (2 pcs) without any issue - so the STM DFU driver works with the RT3s but not with DM-1701.
I always thought, they hat both the STM32 chip inside so they should either both work or none of them.
I also tried serveral other STM DFU driver like the one with "Dfuse_3.0.6_drivers" from the the STM Website...
Anybody any idea how to proceed?
thx
When connecting the DM-1701 (already in Flash-Mode - LED red/green flashing) to my kenwood - USB cabel, I get the warning, that the device was not connected properly. Moreover I get a warning in the Win device-manger - "STM Device in DFU Mode" - but with a waring sign!
Previously my setup (same cable etc) worked flawlessly...
As well as I upgraded my RT3s (2 pcs) without any issue - so the STM DFU driver works with the RT3s but not with DM-1701.
I always thought, they hat both the STM32 chip inside so they should either both work or none of them.
I also tried serveral other STM DFU driver like the one with "Dfuse_3.0.6_drivers" from the the STM Website...
Anybody any idea how to proceed?
thx