Upgrading towards the latest firmware is another issue.. although it is in the correct mode (red/green led flashing on DM1701), I can't succeed upgrading because I have the following feedback in Windows 10. Anyone any ideas ?
Upgrade question
Upgrade question
Maintaining my DM-1701 codeplug without any issues and is working great. Thanks for that.
Upgrading towards the latest firmware is another issue.. although it is in the correct mode (red/green led flashing on DM1701), I can't succeed upgrading because I have the following feedback in Windows 10. Anyone any ideas ?
Upgrading towards the latest firmware is another issue.. although it is in the correct mode (red/green led flashing on DM1701), I can't succeed upgrading because I have the following feedback in Windows 10. Anyone any ideas ?
Re: Upgrade question
Check the Windows Device manager
You should see "STM Device in DFU" in the "Universal Serial Bus controllers", if you don't see this then the driver is not correct.
You should see "STM Device in DFU" in the "Universal Serial Bus controllers", if you don't see this then the driver is not correct.
Re: Upgrade question
I think that is my problem... let's see if I can get that resolved.. Thanks for the tip.Will come back on it
Re: Upgrade question
Installed these drivers (others didn't work) downloads/drivers/Dfuse_3.0.6_drivers.zip and the upgrade process did succeed
Thanks for the help !
Thanks for the help !