TYT MD-UV390 Plus 10W

[F1RMB]

I'll try to jump on a Windows machine with the OpenGD77 CPS software tomorrow. Is the "secure registers" stuff you're looking for obvious from the support window?

Yep, it's a button


Cheers.
---
Daniel

[KO6CDG]

For everyone reading along: the secure registers have been sent.

[F1RMB]

For everyone reading along: the secure registers have been sent.

And received Thanks.


I saw in the other thread, you have two 390Plus, can you send me the secure registers of the other one ?


Cheers.
---
Daniel

[UF3B]

Hi! I can confirm that 390 Plus have output power 10.1 at 435MHz and 8.4 at 145MHz. It was measured by myself at 50 Om load. But my version (without GPS) is not supported by OpenGD, as I realized .

[KB8YKF]

But my version (without GPS) is not supported by OpenGD, as I realized .

OpenGD77 doesn't require GPS. You sure it doesn't work?

[VK3KYY]

But my version (without GPS) is not supported by OpenGD, as I realized .

OpenGD77 doesn't require GPS. You sure it doesn't work?

As previously linked to by someone else, here is a link to W4KWS's video of OpenGD77 on his new UV390 Plus


youtu.be/h0PMK-aohx0

[KQ4MDM]

I have the uv390plus from buytwoway and installed opengd77. I seem to have some issues. When I boot up the screen is black. I push the ptt then the screen will load. I seem to do fine on dmr on my hotspot. However when I try analog I can receive an analog repeaters fine, but if I try to transmit the screen goes black and it does not transmit. I then must turn the top knob to a dmr to get the screen back again. Can anyone advise me?

[UF3B]

But my version (without GPS) is not supported by OpenGD, as I realized .

OpenGD77 doesn't require GPS. You sure it doesn't work?

I tried three times to upload different version of firmware. All I get - dark screen, and few morse sound. I'm already have OpenGD on DM1801, so updating process is not a problem. I think it's because there are more than one version of firmware (and hardware) for Plus version. For example:
10W version GPS+REC
10W version REC
10W version CSV

For my station only 10W version REC firmware is working. And when I load other version of stock FW, I get similar results - black screen.
As I see on video, there is a GPS version which work with openGD.

[KB8YKF]

Unfortunately there are two threads about this issue, but there is a similar report from another user in latest comment of this thread: viewtopic.php?f=19&t=3607&start=10#p28492

[KB8YKF]

I tried three times to upload different version of firmware. All I get - dark screen, and few morse sound.

There is a report in this other thread that pushing PTT button wakes the screen - does that happen for you as well?

viewtopic.php?f=7&t=3617&p=28500#p28491