Page 2 of 2
Re: ALPHA 2022-10-16-01/ RX
Posted: Sun Oct 16, 2022 11:09 pm
by VK3KYY
CU7AAZ wrote: ↑Sun Oct 16, 2022 10:23 pm
Hi to All
Something is happening at the reception, I am 8 km away from a UHF repeater, without obstacles. RT3S connected to outdoor antenna. Normally I get maximum signal, full scale. With rssi of -106db. Before the rssi was -70db +/-. With the radio antenna I had no reception inside the house. I also notice the same with VHF repeaters near me
I tested it with another equipment and the signals are ok.
I don't know if it's the firmware or the hardware...
I don't know if anyone else is having the same problem
Thanks !!
73s
Try on Eco mode 0
Re: ALPHA 2022-10-16-01
Posted: Mon Oct 17, 2022 8:40 am
by EU1AEQ
The absence of sound at the incoming signal was noticed twice (the green LED was on).
1 case. The station was presumably in waiting. More precisely, I do not remember, the sound, it seems, was not in the DMR. Turning the valcoder left-right restored the sound. The event happened unexpectedly, I was not ready.
2 case. The station was in scan. There was no reception on FM. The backlight is in the "buttons" mode, pressing the Fn button turned on the screen, but the sound appeared only after manipulating the valcoder.
ECO=3 is used.In
Re: ALPHA 2022-10-16-01
Posted: Mon Oct 17, 2022 8:51 am
by VK3KYY
What is a "valcoder"
Re: ALPHA 2022-10-16-01/ RX
Posted: Mon Oct 17, 2022 9:51 am
by CU7AAZ
VK3KYY wrote: ↑Sun Oct 16, 2022 11:09 pm
CU7AAZ wrote: ↑Sun Oct 16, 2022 10:23 pm
Hi to All
Something is happening at the reception, I am 8 km away from a UHF repeater, without obstacles. RT3S connected to outdoor antenna. Normally I get maximum signal, full scale. With rssi of -106db. Before the rssi was -70db +/-. With the radio antenna I had no reception inside the house. I also notice the same with VHF repeaters near me
I tested it with another equipment and the signals are ok.
I don't know if it's the firmware or the hardware...
I don't know if anyone else is having the same problem
Thanks !!
73s
Try on Eco mode 0
I did the test in all ECO mode
Thanks
Re: ALPHA 2022-10-16-01
Posted: Mon Oct 17, 2022 10:00 am
by EU1AEQ
VK3KYY wrote: ↑Mon Oct 17, 2022 8:51 am
What is a "valcoder"
Channel selector knob, Rotatory encoder)))
Re: ALPHA 2022-10-16-01
Posted: Mon Oct 17, 2022 10:06 am
by VK3KYY
EU1AEQ wrote: ↑Mon Oct 17, 2022 10:00 am
VK3KYY wrote: ↑Mon Oct 17, 2022 8:51 am
What is a "valcoder"
Channel selector knob, Rotatory encoder)))
OK
Re: ALPHA 2022-10-16-01
Posted: Mon Oct 17, 2022 10:31 am
by VK3KYY