Page 2 of 2
Re: Retained Settings After Flashing OpenGD77 Firmware
Posted: Mon Feb 12, 2024 11:18 pm
by UB3DYP
F1RMB wrote: ↑Mon Feb 12, 2024 3:51 am
Nope, it's not documented for the MD-9600. I will fix that.
Hello, F1RMB!
I rolled back to the firmware from February 2023 and got a "settings updated" response, but the channels remained))) Then I updated the firmware to the latest version. Look at the DMR status on the old firmware "TS2" and on the latest firmware, it's "cS2". Is that okay?
Re: Retained Settings After Flashing OpenGD77 Firmware
Posted: Mon Feb 12, 2024 11:31 pm
by G4EML
This is normal. cS2 indicates that the timeslot is being controlled by your contact setting. When you define a talkgroup or contact you can also assign it a timeslot.
Loading new firmware will never reset the channels. They are defined in the codeplug and that never reset. If you want to remove channels just upload a new codeplug.
Colin G4EML
Re: Retained Settings After Flashing OpenGD77 Firmware
Posted: Tue Feb 13, 2024 12:10 am
by UB3DYP
G4EML wrote: ↑Mon Feb 12, 2024 11:31 pm
This is normal. cS2 indicates that the timeslot is being controlled by your contact setting. When you define a talkgroup or contact you can also assign it a timeslot.
Loading new firmware will never reset the channels. They are defined in the codeplug and that never reset. If you want to remove channels just upload a new codeplug.
Colin G4EML
So, after two firmware updates (old and latest), do I now have the default OpenGD77 settings, and only the channels from the old configuration are saved? Did nothing else from the old settings get preserved?
Re: Retained Settings After Flashing OpenGD77 Firmware
Posted: Tue Feb 13, 2024 1:18 am
by G4EML
Hold P3 when turning on the radio and the press ENT to accept the new settings.
That will reset all settings. Create a new codeplug using the CPS and load it. That will reset all channels.