MD-9600 / RT-90 Installation
Re: MD-9600 / RT-90 Installation
How can I determine which version of MD9600 I have? I tried every version of firmware to identify a good backup firmware file but did not allow the unit to transmit or receive after loading.
Re: MD-9600 / RT-90 Installation
Open the top of the radio and look at the Version number printed on the PCB
Re: MD-9600 / RT-90 Installation
I think the person should read the first post in this thread, since that is where determining the version is and a lot of other info important to replacing the MD-9600 firmware with OpenMD9600.
Re: MD-9600 / RT-90 Installation
Hello friends,
on the board is version V2.1 can I take firmware V1 or V2?
I only read here in the forum that there are V1, V2, V3, V4, V4A and V5
on the board is version V2.1 can I take firmware V1 or V2?
I only read here in the forum that there are V1, V2, V3, V4, V4A and V5
Re: MD-9600 / RT-90 Installation
All early radios have V2.1 boards and should use the V1 or V2 firmware. The only difference is the backlight dimming method. If the backlight dimming doesn't work correctly then use the other version.
Re: MD-9600 / RT-90 Installation
ok got it, thanks a lot friends
Re: MD-9600 / RT-90 Installation
hello friends i have another question
Do I need a normal USB A to Micro USB cable for flashing or do I need a special cable?
I would be happy if I got an answer
Do I need a normal USB A to Micro USB cable for flashing or do I need a special cable?
I would be happy if I got an answer
Re: MD-9600 / RT-90 Installation
Yes , a normal USB A to USB Mini cable should work fine
Then you need the ST DFU driver some older versions are included in the factory software files.
Other you can use the latest driver that is included in the DFUSE demo programmer, I have a copy on my site.
https://www.sa0bux.se/Ham/opengd77/en.stsw-stm32080.zip
Last edited by SA0BUX on Sun Aug 27, 2023 6:38 pm, edited 2 times in total.
Re: MD-9600 / RT-90 Installation
ok because I always get the message no port found ?