2023 Stable release version including source code
2023 Stable release version including source code
The source code for the 2023 stable release version as well as the firmware and voice prompts file can be downloaded from this URL
downloads/releases/MK22/R20231231
downloads/releases/MK22/R20231231
Re: 2023 Stable release version including source code
Thank you
Ciao
Ciao
Re: 2023 Stable release version including source code
With the excuse of extending best wishes for a peaceful 2024, I congratulate all the OpenGD Staff for the tireless and profitable immense work done!!! Well done!!! Happy New Year!!!
Re: 2023 Stable release version including source code
Thank you !
Happy New Year!!!
Happy New Year!!!
Re: 2023 Stable release version including source code
Thanks for all your hard work in creating a great HAM version GD-77
Ron N7RDE
Ron N7RDE
Re: 2023 Stable release version including source code
Good evening, I installed the new stable version of December 31, 2023 on my Radioddity. Previously, the March stable version was installed. After installation the radio no longer turned on. It's the first time it's happened to me. I also tried resetting but nothing. It doesn't turn on and no longer shows any signs of life. Any suggestions? TNX, '73 de IW7DGY
Re: 2023 Stable release version including source code
Try the previous version which worked
Re: 2023 Stable release version including source code -RISOLTO
As suggested by IK0NWG. I disconnected the battery, turned off the power switch, reinstalled the battery, held down SK1+SK2 then turned it on.
It should boot into bootloader mode.
In this case, you download a new binary firmware again, then flash your GD77
Thanks Salvatore! '73
It should boot into bootloader mode.
In this case, you download a new binary firmware again, then flash your GD77
Thanks Salvatore! '73
Re: 2023 Stable release version including source code -RISOLTO
this procedure was suggested by F1RMB Daniel in a previous help request... so thanks goes to Daniel...iw7dgy wrote: ↑Fri Jan 19, 2024 8:16 pmAs suggested by IK0NWG. I disconnected the battery, turned off the power switch, reinstalled the battery, held down SK1+SK2 then turned it on.
It should boot into bootloader mode.
In this case, you download a new binary firmware again, then flash your GD77
Thanks Salvatore! '73
Ciao Aldo
Ciao Daniel
Ciao Roger
Sal