unfortunately the radio also reboot with echo level 3 and echo level 1 in normal mode.
Dmr-id downloaded with cps OpenGD77CPSInstaller_E2021.11.02.01.exe.
Firmware 14 november.
Tell me if I have to do other tests.
Regards, Fabio
IU4LEG wrote: ↑Mon Nov 15, 2021 12:53 pmhi Daniel,
the gd77 was receiving a QSO in DMR mode from a repeater on time slot 1. I confirm that after the restart the message setting update appeared on the display. the radio seemed to have been reset without codeplug and on the vfo it showed the frequency 000000 MHz. turning it off and on again everything went back to normal.
Use version from 14th Nov
Does the radio appear as a com device at all.kt4lh wrote: ↑Tue Nov 16, 2021 1:25 pmI can't read from my my GD77 with this beta either, can anyone help me figure out what's going on? If I revert to the Nov 10 build, it's fine, but Nov 12 or this Nov it can't from the CPS or QDMR.
Huh, okay this is interesting, I've always kept my radio on Eco 4. If I change it to a lower Eco mode, it works. Would having it on Eco mode make it more likely to fail to connect to the radio for CPS download? It's working now for me most of the time in 4, but it still fails randomly.
Nobody else is having issues? I've tried my Anytone 878 on the same cable and a dozen downloads from it not a single failure so I don't think anything has happened to the cable. I have no problems downloading the firmware to the GD77, I've done that 4-5 times over the last few days, just downloading the codeplug from the radio. I haven't tried uploading a codeplug, however.
Also, try turning your radio on with it already connected to the PCkt4lh wrote: ↑Tue Nov 16, 2021 1:25 pmI can't read from my my GD77 with this beta either, can anyone help me figure out what's going on? If I revert to the Nov 10 build, it's fine, but Nov 12 or this Nov it can't from the CPS or QDMR.
Huh, okay this is interesting, I've always kept my radio on Eco 4. If I change it to a lower Eco mode, it works. Would having it on Eco mode make it more likely to fail to connect to the radio for CPS download? It's working now for me most of the time in 4, but it still fails randomly.
Nobody else is having issues? I've tried my Anytone 878 on the same cable and a dozen downloads from it not a single failure so I don't think anything has happened to the cable. I have no problems downloading the firmware to the GD77, I've done that 4-5 times over the last few days, just downloading the codeplug from the radio. I haven't tried uploading a codeplug, however.