CONTROL-T on TYT CPS causes CPS to crash - win 11
Posted: Sat Mar 25, 2023 8:52 pm
Hello,
Tried searching and did not find obvious answers.
I am trying to setup MDUV380 with OGD77 and one of the steps is to read the original calibration and this is done using the original CPS (1.2) and holding CTRL-T. It causes the CPS to crash (exit) in my case or yields an "out of memory" error.
I am able to successfully read the radio (ie. not pressing ctrl-t, but just clicking on the read radio button).
Is this perhaps a known issue to win11?
Prefer to get this cal data saved before I go ahead with the procedure.
Had the same issue on the TYTMD9600... in that case I just did not get the calibration data... I did put the OGD77 FW and seems to work fine
Miguel/kc1lko
Tried searching and did not find obvious answers.
I am trying to setup MDUV380 with OGD77 and one of the steps is to read the original calibration and this is done using the original CPS (1.2) and holding CTRL-T. It causes the CPS to crash (exit) in my case or yields an "out of memory" error.
I am able to successfully read the radio (ie. not pressing ctrl-t, but just clicking on the read radio button).
Is this perhaps a known issue to win11?
Prefer to get this cal data saved before I go ahead with the procedure.
Had the same issue on the TYTMD9600... in that case I just did not get the calibration data... I did put the OGD77 FW and seems to work fine
Miguel/kc1lko