Scan failure in RT3S
Posted: Tue May 30, 2023 1:23 pm
I found a malfunction when scanning RT3S:
DMR simplex and duplex channels were scanned. The duplex channels in my codeplage are written as two channels for TS1 and TS2. There was a conversation in the repeater's TS2. After skipping this channel through 2-3 scanning cycles in the channel of the same repeater TS1, I began to hear what was happening in TS2, while the decoding was distorted.
Perhaps this error was also on previous versions.
P.S.
The error with a specific repeater is steadily repeated. I agree that the repeater may work a little incorrectly, but the DM1801 does not respond to a conversation in a missed TS2 channel. RT3S slows down very much when scanning a missed repeater channel when there is a conversation going on, and the 1801 does not slow down.
Is it possible to fix something in the firmware?
DMR simplex and duplex channels were scanned. The duplex channels in my codeplage are written as two channels for TS1 and TS2. There was a conversation in the repeater's TS2. After skipping this channel through 2-3 scanning cycles in the channel of the same repeater TS1, I began to hear what was happening in TS2, while the decoding was distorted.
Perhaps this error was also on previous versions.
P.S.
The error with a specific repeater is steadily repeated. I agree that the repeater may work a little incorrectly, but the DM1801 does not respond to a conversation in a missed TS2 channel. RT3S slows down very much when scanning a missed repeater channel when there is a conversation going on, and the 1801 does not slow down.
Is it possible to fix something in the firmware?