Scan failure in RT3S

Post Reply
EU1AEQ
Posts: 141
Joined: Sat Jan 30, 2021 7:25 pm

Scan failure in RT3S

Post by EU1AEQ » Tue May 30, 2023 1:23 pm

I found a malfunction when scanning RT3S:
DMR simplex and duplex channels were scanned. The duplex channels in my codeplage are written as two channels for TS1 and TS2. There was a conversation in the repeater's TS2. After skipping this channel through 2-3 scanning cycles in the channel of the same repeater TS1, I began to hear what was happening in TS2, while the decoding was distorted.
Perhaps this error was also on previous versions.

P.S.
The error with a specific repeater is steadily repeated. I agree that the repeater may work a little incorrectly, but the DM1801 does not respond to a conversation in a missed TS2 channel. RT3S slows down very much when scanning a missed repeater channel when there is a conversation going on, and the 1801 does not slow down.
Is it possible to fix something in the firmware?

Post Reply