OpenGD77

Riku had been informed of the error for some time but it seems that not everyone is affected

and where is the failure in ctss activation? what was the fix or modification in the firmware? Does the pre-release ( D20200507)fix it? look video above you see it breaking up when using 2x gd77 witch rx ctcss. the fix is there look few messages back code is there. LINK https://www.opengd77.com/vie...

curiously if it works and charges faster than with the original PCB but same power source, so I intuit that the original PCB limits amps

I am going to try recording from my radio, I have the intuition that it has the same problem with a very strong signal and with active sub tone sometimes it breaks.

I put the new tp15100 module with the original 500mAh charger of the radioddity DG-77 and my surprise charges in only 3 hours, before with the original cpb it took 6 hours + - . From which I deduce that that original PCB or board absorbed part of the energy or limited it.

and where is the failure in ctss activation? what was the fix or modification in the firmware? Does the pre-release ( D20200507)fix it?

I have a source from a charger liitokala 500 that gives 12.5volt and 2amper. Something that if I have won is to avoid the annoying noise that is generated when the battery 100% is above 8.3 + -volt (it generated a small hum the amplifier) . Thank you Sounds like you have this issue, which some do. ...

I have a source from a charger liitokala 500 that gives 12.5volt and 2amper. Something that if I have won is to avoid the annoying noise that is generated when the battery 100% is above 8.3 + -volt (it generated a small hum the amplifier) . Thank you

I have just installed the tp5100 but in output it gives me 8.3 volt Is it normal? Or should I give 8.4? If I use the original charger of only 500ma, will the battery charge well? Obviously it will slow it down. My intention is to have an original 500ma charger for the night and 12v 2a for the day an...

woww