OpenGD77

hi, have just downloaded the very latest firmware and cps everything seems to work ok apart from when i go into extras,calibration, read from radio or load a file i get unhandled exception has occurred in your application value of "1040" is not valid for "value","value" should be between "minimum" a...

Thanks again Roger, I'll check all that out later and adjust with freq, counter and power meter !!
Best regards, Bert G1EUQ ☺

Many many thanks Roger, done as you said and all working with latest firmware, it's amazing what difference 1 digit makes !!!
Best regards and keep up your superb work on these radios, it's much appreciated !!
Bert G1EUQ ☺☺

CAL DATA ERROR hi all, trying to load the latest fw release into my gd77 using open gd77 cps (bd, 20191228) and i get cal data error on booting the radio after installing, the radio is also locked and i have to remove the battery, turn off,and reboot in fw download mode and reload the previous fw v6...

Thanks Roger, that's good to know, when I get five I'll check the versions I've been using and see if I can sort something out

I thought the stable version was the latest, have to admit I find it hard to keep up with development !!!!, I know things change fast with this fw but some kind of identification number would be good

Hi, thanks for the reply, I had already seen that thread on here, I'm just wondering why I have one firmware version that behaves as I think it should but another previous version that never reads above 84% and 8 volts and the latest "stable" version never reads above 8.2 volts and 92/94% , all on a...

I find on the latest "stable" firmware version the battery percentage readout is incorrect so reverted to the previous version and all is well, reading 100% and 8.4 volts on the radio, the stable version doesn't seem to read above 8.0 volts and the appropriate percentage, hope this is an easy fix, a...

hi and thanks for the warm welcome and info, my problem was not having THE latest firmware, having now downloaded and installed all seems to work ok, now trying to get my old brain around the calibration for the power output !!! thanks for all you are doing Roger and keep up the fantastic work, i kn...

panic over, iv'e found the link and all seems well with the world !!!!!