OpenGD77

The APO OFF option does not work when scanning is activated.
If the scanning on the radio starts automatically when you turn on - APO OFF should work regardless of scanning.
It also works in this way?
Tested on MD9600 and DM1801

TOT MD9600 VERSE OF THE V2 after updating firmware APO PWR-OFF option available, set to 30.
APO Witch RF- N. The radio does not turn off. I'm doing something wrong?

This is my calibration file packed ZIP

Colin probably is as you write. I am a 3 user of this device. It came to me as "brick". I'm not sure if there are correct calibration data. I came back to the factory software to check calibration. I do not have a reference point. Did any of my colleagues use a calibration table From your MD9600 in ...

Yes.
I tested the power on the original software.
Power meter indication:
Low - 1.4W;
Low Mid- 8w,
MID - 22W
High - 35 W

Finally, I have a power meter for the 2 m and 70 cm band. I measured the power in both bands for the menu settings. Here are the results: Setting in the menu : =================================================== 100mW 250mW 500mW 750mW 1W 5W 10W 25W 40W ==============================================...

There is a power difference for 2M and 70 cm band. Two repeaters are in the same location. One in the 2M band, the second in the band 70 cm. REPEATERS use one antenna BAFENG DM1801 gains access to them with settings: 1W - 2M converter, 0.5W - converter 70cm. Tyt MD 9600 gets access to them with the ...

I use BAFENG DM 1801. The "DMR Mic" option set to + 12dB.
For TYT MD 9600 (Ver. V2), the "DMR Mic" option set to + 6dB.
Recipients receive a signal from both devices at a similar level.

Thank you very much.

Hello, I have MD 9600
I can test the alpha version.

CPS Version V01.27
Hardware Version V01.00
MCU Version V006.009

DMR ID 2607161

Best wishes.