[DIY: 3D Printed] Bottom charger part for hotspot electronics
[DIY: 3D Printed] Bottom charger part for hotspot electronics
Hi,
I've designed and printed the required parts to embed the hotspot in the original charger.
It's running since yesterday night without EMI problem (250mW).
I've uploaded all the STL and FreeCAD files to Thingiverse.
Enjoy.
---
Daniel
I've designed and printed the required parts to embed the hotspot in the original charger.
It's running since yesterday night without EMI problem (250mW).
I've uploaded all the STL and FreeCAD files to Thingiverse.
Enjoy.
---
Daniel
Re: [DIY: 3D Printed] Bottom charger part for hotspot electronics
Seen this afternoon in action, a superb achievement, with hight precision.... as usual, (I ordered one)
Re: [DIY: 3D Printed] Bottom charger part for hotspot electronics
hello can you please tell me if the 2 cond. are the same 104 ? or they have diffrente values. Thanks a lot
- Attachments
-
- cameringo_2020-02-28_214742-scaled_LI.jpg (495.31 KiB) Viewed 6488 times
Re: [DIY: 3D Printed] Bottom charger part for hotspot electronics
Hi,
Also, you can find a lot of people using some cheap Simplex MMDVM hotspot installed into aluminium case.
Cheers.
---
Daniel
There is also a little piece of copper tape under the RPi. No, there is no huge impact, I wanted to avoid at most is the RF from the transceiver.
Also, you can find a lot of people using some cheap Simplex MMDVM hotspot installed into aluminium case.
Cheers.
---
Daniel