The "mW" difference between versions
The "mW" difference between versions
They noticed a power difference between v0.0.6 and v0.0.72 in HotSpot mode.
Maximum power at version 0.0.6 is 4000mW for me and in version 0.0.72 is 2500mW
Measured at artificial load.
Maximum power at version 0.0.6 is 4000mW for me and in version 0.0.72 is 2500mW
Measured at artificial load.
Re: The "mW" difference between versions
Did you calibrate your power levels for 1W and 5W using the calibration screen in the CPS ?
In the Tier2 version the official calibration data stored in Flash is used, however the offical data is often completely incorrect
In the Tier2 version the official calibration data stored in Flash is used, however the offical data is often completely incorrect
Re: The "mW" difference between versions
I didn't do what you write about.
What should I do to make the power higher in v.0.0.72?
What should I do to make the power higher in v.0.0.72?
Re: The "mW" difference between versions
Yes. After calibration (change of value) the power arrived.
I am afraid when I change to v0.0.6 and forget about changing the calibration value ...
Thank you, Roger
I am afraid when I change to v0.0.6 and forget about changing the calibration value ...
Thank you, Roger