The "mW" difference between versions

Post Reply
User avatar
SQ7PTE
Posts: 123
Joined: Sat Nov 16, 2019 4:23 am
Location: KO00to
Contact:

The "mW" difference between versions

Post by SQ7PTE » Fri Nov 22, 2019 7:06 am

They noticed a power difference between v0.0.6 and v0.0.72 in HotSpot mode.
Maximum power at version 0.0.6 is 4000mW for me and in version 0.0.72 is 2500mW
Measured at artificial load.
Piotr SQ7PTE :roll:

VK3KYY
Posts: 1969
Joined: Sat Nov 16, 2019 3:25 am
Location: Melbourne, Australia
Contact:

Re: The "mW" difference between versions

Post by VK3KYY » Fri Nov 22, 2019 8:45 am

Did you calibrate your power levels for 1W and 5W using the calibration screen in the CPS ?

In the Tier2 version the official calibration data stored in Flash is used, however the offical data is often completely incorrect

User avatar
SQ7PTE
Posts: 123
Joined: Sat Nov 16, 2019 4:23 am
Location: KO00to
Contact:

Re: The "mW" difference between versions

Post by SQ7PTE » Fri Nov 22, 2019 9:16 am

I didn't do what you write about.
What should I do to make the power higher in v.0.0.72?
Piotr SQ7PTE :roll:

VK3KYY
Posts: 1969
Joined: Sat Nov 16, 2019 3:25 am
Location: Melbourne, Australia
Contact:

Re: The "mW" difference between versions

Post by VK3KYY » Fri Nov 22, 2019 9:38 am


User avatar
SQ7PTE
Posts: 123
Joined: Sat Nov 16, 2019 4:23 am
Location: KO00to
Contact:

Re: The "mW" difference between versions

Post by SQ7PTE » Fri Nov 22, 2019 10:24 am

Yes. After calibration (change of value) the power arrived.
I am afraid when I change to v0.0.6 and forget about changing the calibration value ...
Thank you, Roger
Piotr SQ7PTE :roll:

VK3KYY
Posts: 1969
Joined: Sat Nov 16, 2019 3:25 am
Location: Melbourne, Australia
Contact:

Re: The "mW" difference between versions

Post by VK3KYY » Fri Nov 22, 2019 10:29 am

OK

Post Reply