Hi all,
I'm trying to config and use opengd77 (RT3S) with duplex hotspot (I'm not trying to use hotspot mode). I have MMDVM DUAL HAT on Pi-zero W. setting 7MHz split Hotspot TX 434.95 / RX 441.95. and set the radio to TX 441.95 / RX 434.95. I can hear there traffic from the hotspot, but when I push PTT on the radio, the red led will flash and then big "TIMEOUT" on the screen. This always happen when I'm out of a repeater range. So, I'm suspect that the duplex hat is not sending something back and the radio think it is out of range of a repeater and deny to transmit. What have I done wrong here? How to make this work?
any thought?
KA1CM
using OpenGD77 with duplex hotspot
Re: using OpenGD77 with duplex hotspot
Try posting to https://forum.pistar.uk/
But almost certainly you did not calibrate the frequency in your hotspot.
This topic will now be locked as its off-topic and there are other forums which deal with this sort of question
But almost certainly you did not calibrate the frequency in your hotspot.
This topic will now be locked as its off-topic and there are other forums which deal with this sort of question