Show LED when any signal is active

Post Reply
NA7Q
Posts: 80
Joined: Wed Jan 01, 2020 3:41 pm

Show LED when any signal is active

Post by NA7Q » Sat Jan 04, 2020 4:00 am

A huge recommendation for the DMR side of things is having the LED show ANY active signal on the selected frequency. Currently if a signal doesn't match the color code programmed to the memory channel, the LED will not light up.

I had a minor programming error on a channel, and I couldn't figure out why the radio wasn't receiving any signal, or at least why it appeared that way. It was receiving a signal, I just had the wrong color code. This led to some confusion at first when no LED light was displayed.

Post Reply