MD-9600 / RT-90 Installation
Re: MD-9600 / RT-90 Installation
Hi,
It's a mini USB. not a micro.
Cheers.
---
Daniel
It's a mini USB. not a micro.
Cheers.
---
Daniel
Re: MD-9600 / RT-90 Installation
thanks I'll try it out tomorrow and report
Re: MD-9600 / RT-90 Installation
no problem, it was just to avoid to grab/buy a wrong cable.
Cheers.
---
Daniel
Cheers.
---
Daniel
Re: MD-9600 / RT-90 Installation
Unfortunately, all of them didn't work (I'll buy a new cable from the dealer )
Last edited by Torax on Mon Aug 28, 2023 8:33 pm, edited 3 times in total.
Re: MD-9600 / RT-90 Installation
The MD9600 cable is a standard USB A to USB mini cable. There is nothing special about it.
Note however that there are also a lot of 'Power Only' USB mini cables out there that are supplied as charging cables for many devices. They only have the two power wires and no connections for the data lines.
Colin G4EML
Note however that there are also a lot of 'Power Only' USB mini cables out there that are supplied as charging cables for many devices. They only have the two power wires and no connections for the data lines.
Colin G4EML
Re: MD-9600 / RT-90 Installation
Bought a new cable, everything works fine!
thanks to everyone who helped me and thanks to the developers of the firmware (looks great)
thanks to everyone who helped me and thanks to the developers of the firmware (looks great)
Re: MD-9600 / RT-90 Installation
Hi, can I ask what the "J" refers to at the beginning of the firmware files?
Many thanks.
Many thanks.
Re: MD-9600 / RT-90 Installation
Welcome.
I have a rather in my opinion unusual problem, maybe someone can suggest some quick and proven solution.
I have already installed openGD77 on several devices and never had this problem.
I follow the instructions. I put the radio into programming mode, the radio flashes. The connection to the computer is correct. I fire up CPS, first I give the donor file, then the opengd77 software in the latest version.
The installation process begins, after several seconds I have a message that successfully completed and that complete.
There is a disconnection of the radio from the computer and the radio continues to flash, as if in programming mode.
Pressing the power key has no effect.
It's as if something is hanging up.
Disconnecting and re-connecting the power supply does not bring a solution, the radio's display continues to flash.
Do you have any suggestions?
--
73 Pawel SQ9HHT
I have a rather in my opinion unusual problem, maybe someone can suggest some quick and proven solution.
I have already installed openGD77 on several devices and never had this problem.
I follow the instructions. I put the radio into programming mode, the radio flashes. The connection to the computer is correct. I fire up CPS, first I give the donor file, then the opengd77 software in the latest version.
The installation process begins, after several seconds I have a message that successfully completed and that complete.
There is a disconnection of the radio from the computer and the radio continues to flash, as if in programming mode.
Pressing the power key has no effect.
It's as if something is hanging up.
Disconnecting and re-connecting the power supply does not bring a solution, the radio's display continues to flash.
Do you have any suggestions?
--
73 Pawel SQ9HHT