Simultaneous transmission on both time slots.
Posted: Sun Dec 08, 2019 9:08 pm
Hi guys.
Is it only me or very often by transmitting both time slots are used?
I noticed it while I was monitoring on the BrandMeister dashboard.
The thing happens with firmwares 20191206214639[f71b876], 20191207214955[d20eb2e] and 20191208202447[3d77f5b] (next time I will put a screenshot of the display, I promise).
In most cases the activation of both time slots while transmitting occurs individually, but there are cases where it is repeated twice (TSx, TSx and immediately following TSy, TSy) and even three times (TSx, TSx, TSx and immediately after TSy, TSy , TSy).
TSx and TSy are to be understood as TS1 and TS2 or TS2 and TS1, as the first one activated would seem to be the one programmed for the TG, it is not always TS1 and then TS2 or TS2 and then TS1.
At first I thought I had inadvertently set the "Dual Capacity Direct Mode" option, but sadly it was not so.
I did several tests on the local BrandMeister repeater finding that it happens often, only rarely it does not occur.
The thing could be related to other problems that I described in another post (keyboard lock and inability to restore my GD-77 with the original factory firmware from Radioddity), I do not know, however it seemed right to me to warn about the thing.
Thanks.
73 best regards de Fabio IZ2EIB
Is it only me or very often by transmitting both time slots are used?
I noticed it while I was monitoring on the BrandMeister dashboard.
The thing happens with firmwares 20191206214639[f71b876], 20191207214955[d20eb2e] and 20191208202447[3d77f5b] (next time I will put a screenshot of the display, I promise).
In most cases the activation of both time slots while transmitting occurs individually, but there are cases where it is repeated twice (TSx, TSx and immediately following TSy, TSy) and even three times (TSx, TSx, TSx and immediately after TSy, TSy , TSy).
TSx and TSy are to be understood as TS1 and TS2 or TS2 and TS1, as the first one activated would seem to be the one programmed for the TG, it is not always TS1 and then TS2 or TS2 and then TS1.
At first I thought I had inadvertently set the "Dual Capacity Direct Mode" option, but sadly it was not so.
I did several tests on the local BrandMeister repeater finding that it happens often, only rarely it does not occur.
The thing could be related to other problems that I described in another post (keyboard lock and inability to restore my GD-77 with the original factory firmware from Radioddity), I do not know, however it seemed right to me to warn about the thing.
Thanks.
73 best regards de Fabio IZ2EIB