hi, have just downloaded the very latest firmware and cps everything seems to work ok
apart from when i go into extras,calibration, read from radio or load a file i get
unhandled exception has occurred in your application
value of "1040" is not valid for "value","value" should be between
"minimum" and "maximum"
Parameter name: value
any ideas of the cause ??
cps v20200608
fw v june 03 2020 [ 0690263]
the previous cps version does read and write calibration ok but has no voice prompt ability
regards G1EUQ
calibration
Re: calibration
Is this still broken ?