calibration

Post Reply
g1euq
Posts: 23
Joined: Fri Nov 22, 2019 3:25 pm

calibration

Post by g1euq » Mon Jun 08, 2020 7:51 pm

hi, have just downloaded the very latest firmware and cps everything seems to work ok
apart from when i go into extras,calibration, read from radio or load a file i get
unhandled exception has occurred in your application
value of "1040" is not valid for "value","value" should be between
"minimum" and "maximum"
Parameter name: value
any ideas of the cause ??
cps v20200608
fw v june 03 2020 [ 0690263]
the previous cps version does read and write calibration ok but has no voice prompt ability
regards G1EUQ

VK3KYY
Posts: 2996
Joined: Sat Nov 16, 2019 3:25 am
Location: Melbourne, Australia
Contact:

Re: calibration

Post by VK3KYY » Wed Aug 12, 2020 1:07 am

Is this still broken ?

Post Reply