Search found 7579 matches
- Mon Sep 26, 2022 11:58 am
- Forum: TYT MD-UV380/390 / UV380/390 Plus 10W / Retevis RT-3S / Baofeng DM-1701 / DM-1701B / Retevis RT-84
- Topic: [Fixed] DMR Rx dropout
- Replies: 41
- Views: 5442
Re: ALPHA version - Known problems
Can anyone with the dropout problem, please try these versions https://www.opengd77.com/downloads/MDUV380/Firmware/speed_tests They use different CPU clock speeds, and this seems to improve the dropout problem on my radio, even though the CPU clock speed in these tests is lower / slower than in the ...
- Mon Sep 26, 2022 5:56 am
- Forum: TYT MD-UV380/390 / UV380/390 Plus 10W / Retevis RT-3S / Baofeng DM-1701 / DM-1701B / Retevis RT-84
- Topic: ALPHA 2022-09-22-01
- Replies: 15
- Views: 3299
Re: ALPHA 2022-09-22-01
Hi, When updating the firmware, the codeplug, dmrid database and keplerian elements aren't touched. Cheers. --- Daniel As I understand it, jamaxsantos is going to replace the factory firmware with OPENGD77 Yes. As I've stated in the video and in the installation instructions, you must backup the Fl...
- Mon Sep 26, 2022 2:59 am
- Forum: New members must post here first
- Topic: Hello !
- Replies: 3
- Views: 581
Re: Hello !
Welcome.
I have changed your username to your callsign, becuase this is site policy.
I have changed your username to your callsign, becuase this is site policy.
- Mon Sep 26, 2022 2:19 am
- Forum: TYT MD-UV380/390 / UV380/390 Plus 10W / Retevis RT-3S / Baofeng DM-1701 / DM-1701B / Retevis RT-84
- Topic: TYT MD-UV380 / RT-3S Installation information
- Replies: 274
- Views: 139311
Re: ALPHA TYT MD-UV380 / RT-3S Installation information
What will be the problem? Thank you, 73 same on my RT-3S. You have to measure the voltage on the back side, (~ 8.2 Volt is 100%) AFIK. LiPo cels are normally rated at 4.2V to be fully charged. https://en.wikipedia.org/wiki/Lithium_polymer_battery So fully charged battery should be around 8.4V The f...
- Sun Sep 25, 2022 11:50 pm
- Forum: TYT MD-UV380/390 / UV380/390 Plus 10W / Retevis RT-3S / Baofeng DM-1701 / DM-1701B / Retevis RT-84
- Topic: Power calibration may be wrong
- Replies: 2
- Views: 894
Power calibration may be wrong
Please note. I just compared the power output when using the official RT-3S/UV380 firmware, versus the OpenUV380 firmware, and the power output on both 2m and 70cm were not the same. Its likely that the power output is higher than it should be Please check your own power output, and don't use any po...
- Sun Sep 25, 2022 9:21 pm
- Forum: General discussions
- Topic: Not compatible - Baeofeng 1701/1702
- Replies: 8
- Views: 3219
Re: Baeofeng 1701/1702
Its a completely different radio to the DM1801 The hardware of DM-1702 is quite different from DM-1801 - but it's very similar to RT-3s: STM32F405VGT6, HRC6000, AT1846S. So I hope it will be possible to port opengd77 to this radio some time in the future. DM-1702 and DM-X are basically the same rad...
- Sun Sep 25, 2022 10:48 am
- Forum: TYT MD-UV380/390 / UV380/390 Plus 10W / Retevis RT-3S / Baofeng DM-1701 / DM-1701B / Retevis RT-84
- Topic: ALPHA version - Known problems
- Replies: 56
- Views: 15764
Re: ALPHA version - Known problems
Installed the previous firmware version. I can say that there are several times fewer cases of reception interruptions in the new firmware version. There is also information from my friend about the periodic loss of power on the transmission at an installed power of less than 500mW. I have not come...
- Sat Sep 24, 2022 10:51 pm
- Forum: TYT MD-UV380/390 / UV380/390 Plus 10W / Retevis RT-3S / Baofeng DM-1701 / DM-1701B / Retevis RT-84
- Topic: [Fixed] DMR Rx dropout
- Replies: 41
- Views: 5442
Re: ALPHA version - Known problems
I did not notice this problem on my radio, but the problem will be the ADC input, which measures the volume control etc I will try increasing the priority of the ADC interrupt input Unfortunately, if I increase the ADC priority, I have the dropout problem again. The intial problem seems to be that ...
- Sat Sep 24, 2022 9:14 pm
- Forum: TYT MD-UV380/390 / UV380/390 Plus 10W / Retevis RT-3S / Baofeng DM-1701 / DM-1701B / Retevis RT-84
- Topic: [Fixed] DMR Rx dropout
- Replies: 41
- Views: 5442
Re: ALPHA version - Known problems
I did not notice this problem on my radio, but the problem will be the ADC input, which measures the volume control etc
I will try increasing the priority of the ADC interrupt input
I will try increasing the priority of the ADC interrupt input
- Sat Sep 24, 2022 11:44 am
- Forum: TYT MD-UV380/390 / UV380/390 Plus 10W / Retevis RT-3S / Baofeng DM-1701 / DM-1701B / Retevis RT-84
- Topic: [Fixed] DMR Rx dropout
- Replies: 41
- Views: 5442
Re: ALPHA version - Known problems
Can anyone with the DMR Rx signal dropout problem, please try this version
https://opengd77.com/downloads/MDUV380/ ... DUV380.bin
https://opengd77.com/downloads/MDUV380/ ... DUV380.bin