OpenGD77

I will do as you say
Ciao 73 de iz2nab Giancarlo

I will do as you say
Ciao 73 de iz2nab Giancarlo

Sounds familiar. You have to tell us which version of the firmware and CPS you're using. Cheers. --- Daniel Sounds like suspend mode on MK22 radios But this is a STM32 radio Good morning, when the fault occurred, I had installed the firmware version: MD9600-CSV-GPS(2571V5)-P26.45.bin + OpenMDUV380....

Sounds like unmatching CPS/FW (already happened not that long ago, with "auto TX" symptom). Or corrupted FW bin file. But details are missing, definitely. Cheers. --- Daniel Good morning, when the fault occurred, I had installed the firmware version: MD9600-CSV-GPS(2571V5)-P26.45.bin + OpenMDUV380....

New problems on RT3S and Opengd77. After turning it off, the RTX never turns back on, the screen remains black and to turn it back on you have to turn it off and turn it on again by pressing the two side buttons, above and below the PTT. The TS does not change from the rtx options, it always remains...

It's true, but I have read the instructions and I am committed to following them but I see that no instructions have positive results for me.
However, thanks to the precious help found on this forum, I will decide to redo the entire procedure as I read it.
73 of IZ2NAB Giancarlo

yes, in USB in DFU mode the message: "STM Device in DFU mode" appears. From the site "https://www.passion-radio.com/index.php?controller=attachment&id_attachment=760" I downloaded the drivers: "210525 MD-9600 V4 firmware for PLL2571.zip - ZIP archive - non-compressed size of 7,186,974 bytes". I atte...

Today I'm trying to install Open MDUV380, RT3S, the file loads normally in the Boot Update loader, when I give it the command to load in my RT3S it loads it by scrolling the green line, then it stops and starts from scratch. Then I turn it off but the RT3S remains fixed in DFU mode. I have to reloa...

Today I'm trying to install Open MDUV380, RT3S, the file loads normally in the Boot Update loader, when I give it the command to load in my RT3S it loads it by scrolling the green line, then it stops and starts from scratch. Then I turn it off but the RT3S remains fixed in DFU mode. I have to reload...

Hello everyone, I bought a rtx dmr Retevis RT3s, I installed the OpenGD77 program and started the procedure to create a codeplug. First I noticed that the OpenGD77 cps program doesn't install the expected drivers on my PC. In the tests I put the RT3S rtx in DFU mode and during an attempt to enter th...